3/16" Hex Thin Wall Nut Driver

3/32" Takedown punch

1. Our heat treated steel is from American Mills

2. The nice large handle is made in USA

3. Precision machined in the USA

4. Assembled in the USA

5. You are buying direct from the manufacture, that is why our price is lower.

Specifically designed for removing front sights screws from Glock and others.

3/32" diameter punch has our special ball end tip that will help to minimize damage if you slip. Punch is sized perfectly for pushing out the pins by hand.

Large handle fits all hand sizes so you will have a positive and precise grip, sight tool has a 4.7" overall length and punch is 4.5" overall length.

Thin wall hex is needed because the tight clearance between the slide and hex head of the sight screw. Additionally, our front sight tools have a special flat face that allow full contact with the hex head. Heads on the front sight screw are very low profile and sometimes challenging to remove. This design grips the entire head, this will minimize the chance of slipping off and damaging something.