|
|
|
|
|
|
|
|
|
|
|
Fits all sights that require a 4 pin tool. 100% Made in USA, this includes material and labor. Alloy steel with black oxide finish.
|
Simple and easy pin installation when using our 308 detent pin and spring tool. Larger knob helps by providing additional torque when installing stubborn detent pins. Made from alloy steel and 100% Made in USA, this includes material and labor.
|
Squirrel Daddy's gas tube alignment gage makes barrel nut alignment so much easier, it takes the guess work out of tightening the nut.
|
|
|
|
|
|
|
|
|
|
|
|
|
Tapered end .154 diameter pins make a sometimes frustrating alignment simpler,
|
Stainless tapered end .154 diameter pins make a sometimes frustrating alignment simpler,
|
Works with all models of Glock that use a channel liner
|
|
|
|
|
|
|
|
|
|
|
|
|
3/32" Stainless Ball end punch Pin setter on handle
|
Squirrel Daddy .154" anti walk pin set for 15-22 Made in USA
|
Magazine base / floor plate removal tool
|
|
|
|
|
|
|
|
|
|
|
|
|
Muzzle wear gauge for .22LR and .22 short Permanent Laser Markings indicate +, Nom., - tolerance
|
Fits all Glock models channel liner installation tool
|
3/16" hex front sight removal and installation tool
|
|
|
|
|
|
|
|
|
|
|
|
|
3/32" ball end takedown punch and mag floor plate removal tool combo
|
3/32" Ball end punch and 3/16" hex front sight removal tool combo
|
An American made tool for an iconic rifle like the M1 Garand is the only way to go. Our wrench is machined from solid block of 3/8" thick aluminum. Overall length is 7"
|
|
|
|
|
|
|
|
|
|
|
|
|
4" Aluminum "U" channel barrel vise jaw pads will hold upto 3/4" diameter barrel or shaft and smallest is .4" diameter. 100% made in America
|
Fisher Gauge muzzle wear gauge for M1 Garand, M1 Carbine or any other .30 caliber rifle barrel. Measures from .300" to .303" diameter very simply and quickly. 100% made in USA from stainless steel with direct reading permanently laser etched markings.
Typically, when it gets up to .303" diameter its pretty well worn out, less than that depends on how picky you are. Gage reads .30 on the handle and segments indicate last two digits, for example .30 + 15 = .3015 diameter.
|
Made in USA. Highest quality and the lowest price for an upper receiver vise block made from solid aluminum.
|
|
|
|
|
|
|
|
|
|
|
|
|
Highest quality and the lowest price for an upper receiver vise block made from solid aluminum. Made in USA
|
Set of 3 purpose built punches for removal and installation of gas block tube pins.
|
3/32" Ball end punch and 3/16" hex front sight removal tool combo
|
|
|
|
|
|
|
|
|
Pilot pin works with SIG SAUER P320 and many other models.
|
|